6EE7 INSTRUMENTATION LAB
 

1. Study of following parameters of operational amplifiers: Input Impedance, output impedance, input and output offset voltage, Input bias current slew rate, supply voltage rejection ratio (SVRR), Common mode rejection ratio (CMRR), Gain bandwidth product, Gainband width consumption, Transient response.

2. Design and fabricate the following using op-am on breadboard. (i) Inverter (ii) Non inverter (iii) Scalar (iv) summer (v) Differentiator (vi) Integrator

3. Wein bridge oscillator.

4. Filters for first order response. (i) High pass filters (ii) Low pass filters (iii) Notch filter

5. Study an instrumentation amplifier.

6. Study of cathode ray oscilloscope.

7. Draw the characteristics of LVDT

8. Measurement of distance by ultrasonic transducers.

9. Draw the characteristics of RTD, Thermo couple and Thermistor.